PFC驱动部分的，EPWM1-A和EPWM1-B起的什么作用？我看在程序里没有设置它的占空比？ 在Lab4中关于如下代码几个变量的理解 ...

I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

As stated in the title, how to configure one gpio pin as interrupt source. I followed the example "\software_install\C2000Ware_3_02_00_00\driverlib\f28004x\examples\gpio\gpio_ex3_interrupt.c" but I ...

Texas Instruments (TI) Bluetooth® support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search Bluetooth® IC content or ...

My customer is testing ADC's consistency at different temperate. The datasheet says the temperature coefficient is -50/-20 ppm/C When the temperature difference is 50C, the ADC difference should be ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

Texas Instruments (TI) Audio support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search audio IC content or ask ...

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

I'm looking for a DTS chip from a Onkyo network receiver (TX-8050), D830K013BZKB4. This is the correct forum for the processor. This referenced device is custom and requires a license relationship ...

I had a sudden shut down in my PC while my board F28335 was connected to the USB port. After that, I can't work with my DSP board at all and CCS 3.3 doesn't recognize the board. I receive the ...

Hello I have a question about changes in PRU FW between SDK Linux RT version 8.2 and 9.1. When I connect IDK PRU ICSSG port to NIC which starts sending frames after linkUp. There is different behavior ...

I want to know, how to calculate the JESD lane rate for particular parameters for RX--> LMFSHdRx and TX--> LMFSHdTx?. Is there any formula for it?. We are planning to use it for JESD204C. from ...